Ipollo G1 mini RELOAD FACTORY ADDRESS every time I start it

Mining
1

I have few Ipollo G1 mini. I bought the first ones in a batch of x4 and the second ones in a batch of x5.

All the ones from the first batch, work correctly.

But, in two of the second batch, every time I start them, the address resets and the Pool & Woker address to mine, either have a repetitive reverts to the factory-configured worker/address.

Every time I turn them on, IT DOESN´T SEEMS LIKE MY OWN CONFIGURATION DATA HAS BEEN SAVED…

I´m saving my configuration data every day, but it doesn’t seem to be finally saved, and the fuckxd default factory addresses and worker settings keep reverting.

It looks like they’ve been “hacked”, no?

Has anyone else had this problem and/or knows how to fix it?

On the positive side and thanks to their low electricity consumption, I use them every day with my photovoltaic and wind power system (including 75% nighttime use with battery charging) and I’m gradually paying for them, but for free…

Greetings to all

3

Did you install the latest bios version G2.54 by SD (TF) card? If not, there’s your problem.

I did the firmware by upgrade by ethernet at first and anytime there was so much as a microsecond power outage it would reset mine to point to iPollo’s default pool. Quite a tedious affair that was, dealing with 99 active Grin ASICs here, one needs a new control board, finally stopped at the 100 mark. Considering migrating to Tari ASICs by selling off < RTX 4090s (30 series remaining).

4 Likes
4

Thanks to you, I’ve finally solved this problem and I have found the solution… :upside_down_face:

Now I configure it and it keeps all the settings…

I can confirm that this upgrade to the new v2.5.4 firmware is the correct way to solves these inconveniences.

3 Likes